DS Stoves FP16 Panduan Pemilik - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Perapian Dalam Ruangan DS Stoves FP16. DS Stoves FP16 13 halaman. High efficiency hopper fed coal insert

Halaman Cetak

Locating Insert

Liner Hookup To Insert

You will need to attach an appliance

adapter on the bottom end of your liner. Then

you can either put 3 screws in the exhaust

collar of the insert from the outside top of the

insert or from the inside of the firebox. To

access the exhaust collar from the inside of

the insert you will need to remove the coal

hopper and baffle.

CAUTION:

Keep furnishings and other

combustible materials away

from the insert.

Chimney Requirements

Use a Class A stainless steel 6" diameter chimney liner that reaches to the top of your chimney. The

minimum height of a chimney system for the D.S. Fireplace Insert is 20 feet. The chimney must exceed

the roof of a house at a minimum of 3 feet at any point of exit. In a pitched roof installation the chimney

must be 2 feet higher than anything within a 10 foot radius of the chimney. It is important to have a

chimney draft of 0.06 water column. It is required to abide by the manufacturer's instructions on Class A

chimneys as well as local building codes. It is not recommended to build a chimney on an addition that is

lower than the main part of your house. Never connect this unit to a chimney serving another appliance.

Should you have a problem with inadequate draft you should see page 11.

Side View

10 feet