DS Stoves FP16 소유자 매뉴얼 - 페이지 4

{카테고리_이름} DS Stoves FP16에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DS Stoves FP16 13 페이지. High efficiency hopper fed coal insert

Locating Insert

Liner Hookup To Insert

You will need to attach an appliance

adapter on the bottom end of your liner. Then

you can either put 3 screws in the exhaust

collar of the insert from the outside top of the

insert or from the inside of the firebox. To

access the exhaust collar from the inside of

the insert you will need to remove the coal

hopper and baffle.

CAUTION:

Keep furnishings and other

combustible materials away

from the insert.

Chimney Requirements

Use a Class A stainless steel 6" diameter chimney liner that reaches to the top of your chimney. The

minimum height of a chimney system for the D.S. Fireplace Insert is 20 feet. The chimney must exceed

the roof of a house at a minimum of 3 feet at any point of exit. In a pitched roof installation the chimney

must be 2 feet higher than anything within a 10 foot radius of the chimney. It is important to have a

chimney draft of 0.06 water column. It is required to abide by the manufacturer's instructions on Class A

chimneys as well as local building codes. It is not recommended to build a chimney on an addition that is

lower than the main part of your house. Never connect this unit to a chimney serving another appliance.

Should you have a problem with inadequate draft you should see page 11.

Side View

10 feet