DS18 JL- HARNESS Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembicara DS18 JL- HARNESS. DS18 JL- HARNESS 8 halaman.

Halaman Cetak

Ampliﬁer Side Installation

1 - "Front" amplifier audio signal connector: connect this using the supplied

RCA connector and connect this to the amplifier CH1 and Ch2 RCA input.

(Using front speaker upgrade)

"Rear" Amplifier Audio Signal Connector: connect this using the supplied

RCA connector and connect this using "Y" RCA splinter to the amplifier CH3

to CH6 RCA input. (Using a 6CH amplifier with front speaker upgrade)

FACTORY RADIO

HARNESS

DS18

T-HARNESS

RADIO

FACTORY

RADIO

WHITE

WHITE / BLACK

GRAY

GRAY / BLACK

FROM RADIO SIDE

WHITE

WHITE / BLACK

GRAY

GRAY / BLACK

2 - Speaker harness: Connect the Front Speaker Harness to the "Front"

output amplifier channels: White: CH1(+), White/Black: CH1(-), Gray:

CH2(+), Gray/Black: CH2(-) and Connect the Soundbar speaker harness to

the channels 3 to 6 of the amplifier: White: CH3(+), White/Black: CH3(-),

Gray: CH4(+), Gray/Black: CH4(-), Green: CH5(+), Green/Black: CH5(-),

Violet: CH6(+), Violet/Black: CH6(-).

3 - Amplifier Power wires, Red: Positive from the battery, Black: Negative

Ground, Blue: Remote turn-on.

4 - Smart Line Output Conversion Module: this is a Plug and Play connector

using this module (V4HL.V2). This module converts the speaker signal from

the factory radio to a low-level audio signal for the amplifier, this also has a

speaker emulator that enables the signal output of the factory amplifier and

provides the Remote turn-on for the amplifier and LED Module.

DS18 HARNESS

(RADIO SIDE)

SPEAKER /

SIGNAL CONNECTOR

HARNESS SIDE

NOTE: If you use 4 or 5 Channels

amplifier without upgrading the

front speaker you will need to

bypass the "Front" signal. Use only

the "Rear" signal to JL-SBAR or

subwoofer channels.

Cut the wires: White CH1(+),

White /Black CH1(-), Gray CH2(+)

and Gray/Black CH2(-) from each

Harness side speaker/signal

connector and connect each same

color together using crimp wire

connectors: