DS18 JL- HARNESS Manuale d'uso - Pagina 5
Sfoglia online o scarica il pdf Manuale d'uso per Altoparlanti DS18 JL- HARNESS. DS18 JL- HARNESS 8.
Stampa la pagina
Amplifier Side Installation
1 - "Front" amplifier audio signal connector: connect this using the supplied
RCA connector and connect this to the amplifier CH1 and Ch2 RCA input.
(Using front speaker upgrade)
"Rear" Amplifier Audio Signal Connector: connect this using the supplied
RCA connector and connect this using "Y" RCA splinter to the amplifier CH3
to CH6 RCA input. (Using a 6CH amplifier with front speaker upgrade)
FACTORY RADIO
HARNESS
DS18
T-HARNESS
RADIO
FACTORY
RADIO
WHITE
WHITE / BLACK
GRAY
GRAY / BLACK
FROM RADIO SIDE
WHITE
WHITE / BLACK
GRAY
GRAY / BLACK
2 - Speaker harness: Connect the Front Speaker Harness to the "Front"
output amplifier channels: White: CH1(+), White/Black: CH1(-), Gray:
CH2(+), Gray/Black: CH2(-) and Connect the Soundbar speaker harness to
the channels 3 to 6 of the amplifier: White: CH3(+), White/Black: CH3(-),
Gray: CH4(+), Gray/Black: CH4(-), Green: CH5(+), Green/Black: CH5(-),
Violet: CH6(+), Violet/Black: CH6(-).
3 - Amplifier Power wires, Red: Positive from the battery, Black: Negative
Ground, Blue: Remote turn-on.
4 - Smart Line Output Conversion Module: this is a Plug and Play connector
using this module (V4HL.V2). This module converts the speaker signal from
the factory radio to a low-level audio signal for the amplifier, this also has a
speaker emulator that enables the signal output of the factory amplifier and
provides the Remote turn-on for the amplifier and LED Module.
DS18 HARNESS
(RADIO SIDE)
SPEAKER /
SIGNAL CONNECTOR
HARNESS SIDE
NOTE: If you use 4 or 5 Channels
amplifier without upgrading the
front speaker you will need to
bypass the "Front" signal. Use only
the "Rear" signal to JL-SBAR or
subwoofer channels.
Cut the wires: White CH1(+),
White /Black CH1(-), Gray CH2(+)
and Gray/Black CH2(-) from each
Harness side speaker/signal
connector and connect each same
color together using crimp wire
connectors:
4