DSC PC1550 Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Papan tombol DSC PC1550. DSC PC1550 9 halaman. 4 digit master code
Juga untuk DSC PC1550: Buku Petunjuk (17 halaman), Buku Petunjuk (17 halaman), Buku Petunjuk (17 halaman), Buku Petunjuk (17 halaman), Buku Petunjuk (12 halaman)

Halaman Cetak

Reset

To restore the smoke detector(s) to normal, press [

has smoke in it, the alarm will resound and the sequence described above

will repeat. If the detector is clear of smoke, the system will return to

normal.

NOTE: If you suspect that the communicator has transmitted and there is

no fire condition, call the monitoring station to avoid an

unnecessary response.

If a fire condition is apparent, follow your evacuation plan

immediately. If the alarm sounds at night, evacuate

immediately.

Testing Your System

It is recommended that you test your system weekly.

NOTE: Perform system tests in the off-peak hours, such as early morning

or late evening.

1. Inform the monitoring station that you are testing your system.

2. Disarm the system ("Ready" light ON).

3. Perform a bell/battery test by pressing [

signal will sound for about 2 seconds. If a trouble occurs after the test,

press [

][2] to view the trouble condition.

4. Activate each sensor in turn (e.g. open a door/window or walk in motion

detector areas). Observe the zone light come ON when the zone is

activated. The zone light will go OFF when the system restores to

normal (i.e. door or window closed).

5. If they are programmed for operation, press the [F], [A], and [P] keys in

turn. The [F] key will sound the bell/siren in a pulsed mode. Enter the

access code to silence the alarm. The [A] key is silent. The [P] key may

be programmed as silent or audible. If the alarm sounds, enter the

access code to silence.

6. If the panel has a zone programmed for fire, activation will cause the

alarm signal to sound in a pulsed mode.

CAUTION: Do not use an open flame or burn materials to test a smoke

detector. Contact your alarm installer for information on safe methods to

activate a smoke detector.

7. Should the system fail to operate properly, call your alarm dealer for

service.

8. When testing is complete, call and advise the monitoring station.

Maintenance

With normal use, the system requires minimum maintenance. The following

points should be observed.

1. Do not wash the keypad with a wet cloth. Light dusting with a barely

damp cloth should remove normal accumulations of dust.

2. The battery/bell test is designed to determine battery condition, however

it is recommended that the standby battery be replaced every three

years.

3. For other system devices such as passive infrared, ultrasonic or

microwave motion detectors, glassbreak detectors or smoke detectors,

consult the respective manufacturer's literature for testing and

maintenance.

][7]. If the detector still

][6][Master Code][8]. The