DSP AD1200 Instruksi - Halaman 7

Jelajahi secara online atau unduh pdf Instruksi untuk Telepon DSP AD1200. DSP AD1200 12 halaman.

Halaman Cetak

2.12 Entering Telephone Numbers

Up to 8 telephone numbers can be programmed, these are in locations 11 – 18. Each telephone
number should not be longer than 24 digits.
Press: PROG
1
Repeat the procedure for programming telephone numbers 2 – 8 in locations 12-18.
2.13 Programming Slow Dialing Telephone Numbers
If dialing a telephone number with a connection problem, the AD1200 can be programmed to slow
Press: PROG
Enter telephone number location
appears on the display, enter telephone number

2.14 Recall Entered Telephone Numbers

Programmed telephone numbers can be recalled and displayed on the seven segment display.
Press: READ
PROG
2.15 Deleting A Telephone Number
Press:
PROG
Enter telephone number location

2.16 Deleting All Telephone Numbers

Press:
PROG
1

2.17 Recording Voice Message

The voice message recoding duration is 20 seconds. The microphone is located between the Dial
& PWR LEDs. To start to record your voices message:
Press: VOICE
When releasing the voice key, LED display will show ▬ indicating you should
start speaking into the microphone.
will extinguish indicating recoding has finished. To playback and listen to voice
message you have to exit installer programming and enter installer test mode.

2.18 Exit Installer Programming

Enter installer code:
?
AD1200 Installer Manual, Rev. 19.06.2013
1
Enter 1st telephone number to be dialed.
Press:
Enter telephone number location
9
?
?
?
Press:
6
Press:
?
?
Press:
PROG
ENTER
?
?
?
?
ENTER
After 20 seconds the ▬ on the display
ENTER
www.dsp-technology.com
ENTER