DSP AD1200 Instruksi - Halaman 9

Jelajahi secara online atau unduh pdf Instruksi untuk Telepon DSP AD1200. DSP AD1200 12 halaman.

2.25 Setting Remote Device Type

Each of the eight Remote Devices may be setup to one of the following different functionalities:



Remote Panic Button:



Remote Arming:



Remote Disarming:



Remote Arming / Disarming:

To assigned a type code to a Remote Device the following requirements must be fulfilled:



The hardware of the AD1200 must be equipped with the optional Remote Device function-

ality



The Remote Device feature is enabled as described under 2.21



A Remote device was previously recorded on the desired location as described under 2.22

The installer may now continue the following procedure to set the desired Device Type:

Press: PROG

Enter the desired Device Type Code (1, 2, 4 or 6)

The Installer may reset all programming locations by entering:

Press : ENTER

Another way to reset all programming locations is the following: Switch the power off, link out the

two pins marked with "Factory Reset", power up the unit and remove link.

Note: If you have burnt in your Installer Code, the Installer Code can not be reset to the

default value 7777. The unit must be sent back to the factory for repair.

There are no user serviceable parts contained within this unit.

DO NOT attempt to interfere with, or alter any of the electronic components. To do so, may dam-

age the electronic circuitry and will invalidate you warranty.

Every effort has been made to provide accurate information, however, slight variations can occur.

We reserve the right to make changes for the product improvement at anytime.

AD1200 Installer Manual, Rev. 19.06.2013

Type Code 1

Type Code 2

Type Code 4

Type Code 6

Enter the desired Remote Device locations (1 ... 8)