ATT Holding Kade KZ-700-U/H Panduan Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pengontrol Akses IP ATT Holding Kade KZ-700-U/H. ATT Holding Kade KZ-700-U/H 12 halaman. Integrated access controller

Halaman Cetak

Integrated Access Controller – Installation manual

Remarks:

The Zone 2, it can be used to operate the door bell when no need to operate a

second door. The wiring is connecting the door bell to NO2 and COM2. Press #,

the reader will send out a switching signal to the door bell, as long as you press

the" #", the door bell will continuous operate, it will stop until you release the #

Connect the negative pole of the lock to NC is for Fail–safe lock.

Connect the negative pole of the lock to NO is for Fail-secure lock.

Relay operation (Pulse mode and Toggle mode)

The relay on board can operate in Pulse Mode (suitable for access control) or

Toggle Mode (suitable for arming/disarming alarms, switching lights, ma-

chines.etc)

Every time a valid tag/card read or PIN input in Pulse Mode, the relay will oper-

ate, for the pre-set relay pulse time.

Every time a valid tag/card read or PIN input in Toggle Mode, the relay changes

state, which will not turn back until read card or input PIN again.

Reset to Factory Default

To reset to factory default, power off, press *, hold it and power on, release it

until hear two beeps and the LED shines in orange, then read any two EM or HID

cards, the LED will turn in red, means reset to factory default setting successful-

ly. Of the two cards read, the first one is Manager Add Card, the second one is

Manager Delete Card.

Remarks: Reset to factory default, the user's information is still retained.

Anti Tamper Alarm

The KZ-700-U/H uses a LDR (light dependent resistor) as an anti tamper alarm.

If the keypad is removed from the cover then the tamper alarm will operate.

Operation Status

Zone 1, unlock

Zone 2, unlock

Power on

Stand by

Press keypad

Operation successful

Operation failed

Enter into programming mode

In the programming mode

Exit from the programming mode

Alarm

Sound and Light indication

Red Light

Green Light

Bright

Shines slowly

Bright

Shines slowly

Shines quickly

Blue Light

Bright

Off

Bright

off

Bright

Buzzer

Short Ring

Long Ring

Short Ring

Long Ring

3 Short Rings

Long Ring

Alarm