ATTI Shadow Tracker Premier Manual Perangkat Keras - Halaman 9

Jelajahi secara online atau unduh pdf Manual Perangkat Keras untuk GPS ATTI Shadow Tracker Premier. ATTI Shadow Tracker Premier 16 halaman. Vehicle tracking system
Juga untuk ATTI Shadow Tracker Premier: Manual Perangkat Keras (16 halaman)

C
ONNECTING THE UNIT

Wiring Instructions

The Red wire must be connected to a CONSTANT 12 volt positive power source,
it MUST have power even when the vehicle is turned off. The Blue wire should
be connected to a switched 12 volt positive power source, it should have power
ONLY when the vehicle is running and NOT when the vehicle is turned off. This
tells the Shadow Tracker™ Premier unit that the vehicle is turned off verifying
that the vehicle must be stopped. If you can not locate a switched power source
then the Blue wire MUST be connected to the same constant power source as
the Red wire. (Note: If the Blue wire is connected to a continuous power source
then the stop reporting may not be as accurate. The Blue wire MUST be
connected to a power source, either constant or switched or the Tracker unit will
NOT collect GPS data.) The Black wire must be connected to a 12 volt ground
source.

Status Indicator Lights

Once power is properly connected the
the front panel of the Shadow Tracker™ Premier will glow.
The
Power
LED indicator will be red when the unit is receiving power. When the
unit is downloading the
The
GPS
LED indicator is green when satellite information is being acquired.
The
GPS
light is orange when no satellites are visible and the unit is unable to
successfully track it's position. If this occurs on a regular basis you may need to
reposition the antenna.
Upon the initial power up or after extended periods of non use it may take up to
10 minutes to acquire (
acquired, if power is turned off and on the acquisition time will normally be less
than one minute.
If the unit does not successfully power up, refer to the trouble shooting section located at the back of the manual. The unit
power should be disconnected when left for extended periods of time.
Power
Transmit
LED indicator will blink.
GPS
LED will turn green) satellites. Once the unit has
4
LED and
GPS
LED light located on
Status Indicator Lights