ATTI Shadow Tracker Premier Manual do hardware - Página 9

Procurar online ou descarregar pdf Manual do hardware para GPS ATTI Shadow Tracker Premier. ATTI Shadow Tracker Premier 16 páginas. Vehicle tracking system
Também para ATTI Shadow Tracker Premier: Manual do hardware (16 páginas)

Imprimir página

ONNECTING THE UNIT

Wiring Instructions

The Red wire must be connected to a CONSTANT 12 volt positive power source,

it MUST have power even when the vehicle is turned off. The Blue wire should

be connected to a switched 12 volt positive power source, it should have power

ONLY when the vehicle is running and NOT when the vehicle is turned off. This

tells the Shadow Tracker™ Premier unit that the vehicle is turned off verifying

that the vehicle must be stopped. If you can not locate a switched power source

then the Blue wire MUST be connected to the same constant power source as

the Red wire. (Note: If the Blue wire is connected to a continuous power source

then the stop reporting may not be as accurate. The Blue wire MUST be

connected to a power source, either constant or switched or the Tracker unit will

NOT collect GPS data.) The Black wire must be connected to a 12 volt ground

source.

Status Indicator Lights

Once power is properly connected the

the front panel of the Shadow Tracker™ Premier will glow.

The

Power

LED indicator will be red when the unit is receiving power. When the

unit is downloading the

The

GPS

LED indicator is green when satellite information is being acquired.

The

GPS

light is orange when no satellites are visible and the unit is unable to

successfully track it's position. If this occurs on a regular basis you may need to

reposition the antenna.

Upon the initial power up or after extended periods of non use it may take up to

10 minutes to acquire (

acquired, if power is turned off and on the acquisition time will normally be less

than one minute.

If the unit does not successfully power up, refer to the trouble shooting section located at the back of the manual. The unit

power should be disconnected when left for extended periods of time.

Power

Transmit

LED indicator will blink.

GPS

LED will turn green) satellites. Once the unit has

LED and

GPS

LED light located on

Status Indicator Lights