2B Technologies 306 Petunjuk Memulai - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Memulai untuk Alat Ukur 2B Technologies 306. 2B Technologies 306 4 halaman.

4. With your Model 306 attached to your ozone monitor via the connection tube, you may now

begin generating ozone. Press the select switch on the front of the instrument and scroll to

"O3" in the menu. Set the desired amount of ozone and press the select switch again to

begin generating ozone.

5. Allow the bar located on the LCD to max out before you begin logging your measurements.

6. At this point your Model 306 is fully operational and may be used for calibration.

7. Please

contact

http://twobtech.com/techsupport.htm

Model 306 Installation Guidelines

Typical Installation: Connection to a Device Drawing Flow from the Model 306

The Model 306 is frequently used to calibrate an ozone monitor or to provide a known ozone

concentration to another kind of equipment that draws flow from the calibrator. The Model 306 is

designed for this type of installation. Inside the Model 306, an air pump maintains a total flow of ~

3 L/min through the ozone generator. Any portion of the total flow that is not being drawn into the

user's equipment is vented through an internal ozone scrubber and vented inside the enclosure

(Figure 1).

Model 306 Ozone Calibration Source

Air

Pump

Figure 1. Schematic of the Model 306 showing the internal overflow scrubber

2B Technologies

2100Central Ave Suite 105, Boulder, Colorado 80301 USA

Phone 303-273-0559 Fax 303-277-1812 http://www.twobtech.com

Technologies

Ozone

Generato

and vent for any unused portion of the total flow rate.

(303)-273-0559

if you have any problems.

Internal

Vent

Overflo

Scrubb

via

the

web

User's

Equipme

Model 306 Quick Start Guide Rev B