2B Technologies 306 Instructies voor opstarten - Pagina 2
Blader online of download pdf Instructies voor opstarten voor {categorie_naam} 2B Technologies 306. 2B Technologies 306 4 pagina's.
Pagina afdrukken4. With your Model 306 attached to your ozone monitor via the connection tube, you may now
begin generating ozone. Press the select switch on the front of the instrument and scroll to
"O3" in the menu. Set the desired amount of ozone and press the select switch again to
begin generating ozone.
5. Allow the bar located on the LCD to max out before you begin logging your measurements.
6. At this point your Model 306 is fully operational and may be used for calibration.
7. Please
contact
http://twobtech.com/techsupport.htm
Model 306 Installation Guidelines
Typical Installation: Connection to a Device Drawing Flow from the Model 306
The Model 306 is frequently used to calibrate an ozone monitor or to provide a known ozone
concentration to another kind of equipment that draws flow from the calibrator. The Model 306 is
designed for this type of installation. Inside the Model 306, an air pump maintains a total flow of ~
3 L/min through the ozone generator. Any portion of the total flow that is not being drawn into the
user's equipment is vented through an internal ozone scrubber and vented inside the enclosure
(Figure 1).
Model 306 Ozone Calibration Source
Air
Pump
Figure 1. Schematic of the Model 306 showing the internal overflow scrubber
2B Technologies
2100Central Ave Suite 105, Boulder, Colorado 80301 USA
Phone 303-273-0559 Fax 303-277-1812 http://www.twobtech.com
2B
Technologies
Ozone
Generato
r
and vent for any unused portion of the total flow rate.
at
(303)-273-0559
if you have any problems.
Internal
Vent
Overflo
w
Scrubb
er
or
via
the
web
User's
Equipme
nt
Model 306 Quick Start Guide Rev B
at