AddBike Carry'Box Module Panduan Pengguna dan Instalasi - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pengguna dan Instalasi untuk Aksesori Sepeda AddBike Carry'Box Module. AddBike Carry'Box Module 16 halaman. Applicable to the addbike and addbike+
Juga untuk AddBike Carry'Box Module: Panduan Pengguna dan Instalasi (18 halaman), Buku Petunjuk (18 halaman)
Halaman Cetak
Screw the provided compact slat to the lower front tubes with the 4 screws BHC M5x30 and
•
corresponding nuts. You should end up with a set as shown in figure
During this step, if your AddBike isn't equipped with 4 plastic caps at the 4 bar
ends of the backrest and base structure (at the level of the connection sleeve),
the only preparation to install the bars is to remove the screws at each bar end
(screw without nut). Once the bars are inserted as shown below, tighten the
screws (screw without nut).
Remove the screws, nuts and plastic cap from both sides of the compact plate of the
•
AddBike's seat. Also remove the screws, nuts and plastic cap from both sides of the highest
compact plate of the AddBike's
Screws and nuts to be removed
Plastic caps to be removed
Screws and nuts to be removed
VERSION V4.1
Figure 3 – Fixing the compact slat to the lower tubes
backrest;
Figure 4 – Screws and plastic caps to be removed
1;
7