AddBike Carry'Box Module 사용자 및 설치 설명서 - 페이지 7

{카테고리_이름} AddBike Carry'Box Module에 대한 사용자 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AddBike Carry'Box Module 16 페이지. Applicable to the addbike and addbike+
AddBike Carry'Box Module에 대해서도 마찬가지입니다: 사용자 및 설치 설명서 (18 페이지), 사용 설명서 (18 페이지)

페이지 인쇄

Screw the provided compact slat to the lower front tubes with the 4 screws BHC M5x30 and

•

corresponding nuts. You should end up with a set as shown in figure

During this step, if your AddBike isn't equipped with 4 plastic caps at the 4 bar

ends of the backrest and base structure (at the level of the connection sleeve),

the only preparation to install the bars is to remove the screws at each bar end

(screw without nut). Once the bars are inserted as shown below, tighten the

screws (screw without nut).

Remove the screws, nuts and plastic cap from both sides of the compact plate of the

•

AddBike's seat. Also remove the screws, nuts and plastic cap from both sides of the highest

compact plate of the AddBike's

Screws and nuts to be removed

Plastic caps to be removed

Screws and nuts to be removed

VERSION V4.1

Figure 3 – Fixing the compact slat to the lower tubes

backrest;

Figure 4 – Screws and plastic caps to be removed