3onedata IES2100SL-16T-2LV Panduan Instalasi Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi Cepat untuk Beralih 3onedata IES2100SL-16T-2LV. 3onedata IES2100SL-16T-2LV 3 halaman. Unmanaged industrial ethernet switch

Halaman Cetak

10/100Base-T(X) 100M copper port (1-5/8/16)

【Mounting Dimension】

Unit: mm

Model I



Model II



Model III



Notice Before Mounting:

Don't place or install the device in area near water or



moist, keep the relative humidity of the device

surrounding between 5%~95% without condensation.

Before power on, first confirm the supported power



supply specification to avoid over-voltage damaging the

device.

The device surface temperature is high after running;



please don't directly contact to avoid scalding.

【DIN-Rail Mounting】

The product adopts 35mm standard DIN-Rail mounting which

is suitable for most industrial scenes, mounting steps as

follows:

Check if the DIN-Rail mounting kit is installed firmly.

Insert the bottom of DIN-Rail mounting kit (one side

with spring support) into DIN-Rail, and then insert

the top into DIN-Rail.

Tips:

Insert a little to the bottom, lift upward and then insert

to the top.

Check and confirm the product is firmly installed on

DIN-Rail, then mounting ends.

【Disassembling DIN-Rail】

Power off the device.

After lifting the device upward slightly, first shift out

the top of DIN-Rail mounting kit, and then shift out

the bottom of DIN-Rail, disassembling ends.

Notice before power on:

Power ON operation: First insert the power supply



terminal block into the device power supply interface,

then plug the power supply plug contact and power on.

Power OFF operation: First, remove the power plug,



then remove the wiring section of terminal block. Please

pay attention to the above operation sequence.

【Power Supply Connection】

Provide 2 power inputs, and adopt

4-pin 5.08mm pitch terminal blocks.

The power input supports 1 power

supply alone or 2 power supply at

the same time; When two power

supplies input at the same time, it

supports redundant backup of power supply. If one power

supply fails, the device can still work normally without

interruption. Power supply supports anti-reverse connection,

which cannot power the device but won't damage it when it's

reversely connected. The definitions of power pin are shown

in the figure above, and the power input range is 12/24/48

VDC (49~60VDC).

【DIP Switch Settings】

Provide 4 pins DIP switch for function settings, where "ON" is

enable valid terminal. The definitions of DIP switch are as

follows:

Model I



DIP Switch Definition

Operation

Set the switch to ON to enable

port loop detection function.

When the loop is detected, the

Loop

communication of one port will

Detection

be blocked to avoid the storm,

and the indicator of the loop

port will flash to warn.