Attop X-PACK 10 Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Quadcopters Attop X-PACK 10. Attop X-PACK 10 6 halaman.

6. Installation

(1) Open up all 4 blades for the drone.
This aircraft is a folding structure, please make sure to open all four blades before
taking off.
(2) Blades Protector Installing.
Expand the buckle of the protector, and install it onto the drone wings.
(3) Replace the propellers when it's needed. (Optional)
B
a. Loosen the screws, then remove the cap.
b. Take out the propellers.
c. Fit the spare propellers into the drone according to the mark (A/B) on them.
d. Install the cap and tighten the screws.
Note:
Please do not overtighten the screws. Gently rotate the propellers by
hand after installation to check whether they are rotatable, if not, please
loosen the screw and check again.
7. How to Fly
(1) Switch on the power.
First power on the drone.
1
(Keep pressing for 2 seconds
and place it on a flat ground
or surface.)
(2) Frequency matching.
1
After turning on the drone, both indicator lights
on the drone and controller will flash, then
2
push the left throttle to the top, then down to
the lowest, after 2 seconds, the indicators will
go steady, which means the frequency
matched successfully.
(3) Compasses calibration.
Move both control sticks to lower left at 45°,
you'll hear a beep from the remote. Calibration
completes when the LEDs of the drone turn
to solid on from flashing.
A
4
Press and hold the ON/OFF
2
button to turn on the controller,
you will hear a beep from the
controller and its LED indicator
starts flashing.
6
(4) Install the battery into the drone after it's fully charged.
(5) Install the controller batteries.
A M4 . L R0 3 SI Z E A A A
A M4 .L R03 S IZ E AA A
D C 1 . 5 V
D C 1 . 5 V
A M4 .L R03 S IZ E AA A
D C 1 . 5 V
A M4 .L R03 S IZ E AA A
A M4 . L R0 3 SI Z E A A A
D C 1 . 5 V
D C 1 . 5 V
A M4 . L R0 3 SI Z E A A A
D C 1 . 5 V
3 x 1.5V AAA (Batteries are not included.)
When the controller's battery is low, there are continuous beeps from
the remote and its LED indicator keeps flashing.
(6) Unfold the phone clamp to place your mobile device.
(4) Flight Instructions
Option 1:
Press the
button to take off.
Option 2:
Simultaneously push the Left Control Stick to lower left at 45° and the
Right Control Stick to lower right at 45° (or push the Left Control Stick to
lower right at 45° and the Right Control Stick to lower left at 45°) until
the four propellers start rotating, then slowly push the Left Control Stick
forward to take off.
OR
After frequency matching and calibration
Option 3:
finished, you can hold the aircraft in your
Throw-to-fly function
hand, and then horizontally throw it out.
The aircraft will automatically unlock the
blades and fly in the air.
Note: It is better to operate the calibration
step again after operating throw-to-fly for
several times. The function will be more
stable.
AM 4. LR 03 SI ZE AAA
D C 1 . 5 V
AM 4. LR 03 SI ZE AAA
D C 1 . 5 V
AM 4. LR 03 SI ZE AAA
D C 1 . 5 V
1
2
5
7