Attop X-PACK 10 Kullanıcı Kılavuzu - Sayfa 2

Quadcopterler Attop X-PACK 10 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Attop X-PACK 10 6 sayfaları.

Sayfayı Yazdır

6. Installation

(1) Open up all 4 blades for the drone.

This aircraft is a folding structure, please make sure to open all four blades before

taking off.

(2) Blades Protector Installing.

Expand the buckle of the protector, and install it onto the drone wings.

(3) Replace the propellers when it's needed. (Optional)

a. Loosen the screws, then remove the cap.

b. Take out the propellers.

c. Fit the spare propellers into the drone according to the mark (A/B) on them.

d. Install the cap and tighten the screws.

Note:

Please do not overtighten the screws. Gently rotate the propellers by

hand after installation to check whether they are rotatable, if not, please

loosen the screw and check again.

7. How to Fly

(1) Switch on the power.

First power on the drone.

(Keep pressing for 2 seconds

and place it on a flat ground

or surface.)

(2) Frequency matching.

After turning on the drone, both indicator lights

on the drone and controller will flash, then

push the left throttle to the top, then down to

the lowest, after 2 seconds, the indicators will

go steady, which means the frequency

matched successfully.

(3) Compasses calibration.

Move both control sticks to lower left at 45°,

you'll hear a beep from the remote. Calibration

completes when the LEDs of the drone turn

to solid on from flashing.

Press and hold the ON/OFF

button to turn on the controller,

you will hear a beep from the

controller and its LED indicator

starts flashing.

(4) Install the battery into the drone after it's fully charged.

(5) Install the controller batteries.

A M4 . L R0 3 SI Z E A A A

A M4 .L R03 S IZ E AA A

D C 1 . 5 V

A M4 .L R03 S IZ E AA A

D C 1 . 5 V

A M4 .L R03 S IZ E AA A

A M4 . L R0 3 SI Z E A A A

D C 1 . 5 V

A M4 . L R0 3 SI Z E A A A

D C 1 . 5 V

3 x 1.5V AAA (Batteries are not included.)

When the controller's battery is low, there are continuous beeps from

the remote and its LED indicator keeps flashing.

(6) Unfold the phone clamp to place your mobile device.

(4) Flight Instructions

Option 1:

Press the

button to take off.

Option 2:

Simultaneously push the Left Control Stick to lower left at 45° and the

Right Control Stick to lower right at 45° (or push the Left Control Stick to

lower right at 45° and the Right Control Stick to lower left at 45°) until

the four propellers start rotating, then slowly push the Left Control Stick

forward to take off.

After frequency matching and calibration

Option 3:

finished, you can hold the aircraft in your

Throw-to-fly function

hand, and then horizontally throw it out.

The aircraft will automatically unlock the

blades and fly in the air.

Note: It is better to operate the calibration

step again after operating throw-to-fly for

several times. The function will be more

stable.

AM 4. LR 03 SI ZE AAA

D C 1 . 5 V

AM 4. LR 03 SI ZE AAA

D C 1 . 5 V

AM 4. LR 03 SI ZE AAA

D C 1 . 5 V