DTI HV-500 Deskripsi Teknis - Halaman 18

Jelajahi secara online atau unduh pdf Deskripsi Teknis untuk Inverter DTI HV-500. DTI HV-500 18 halaman.

HV-500 TECHNICAL DESCRIPTION

(BETA

VERSION)

High voltage wiring

First of all, read

"LIABILITY AND SAFE USE OF THIS

UNIT". The wiring of the high voltage must be carried

out by a specialist. Keep in mind that DC high voltage is very dangerous and deadly.

Wait for the discharge time before disconnecting the high-voltage connectors.

Wait minimum 6 minutes

after switch off the DC voltage.

Use a shielded wire with appropriate shielding points. The AC-side wires must only be connected to the

ground at the motor side. The wires should be as short as possible and as close to each other as possible.

This way the inductance of the wire can be minimized. Please read the CP-600 connector user manual

before use CP-600 connectors

High voltage and low voltage must be electrically isolated. The isolation monitor monitors the isolation

existence. If the monitor detects any error, must turn off the high voltage system.

First install the low voltage part separately and test the peripherals. Use current control mode in the App

Setting/Analog I/O / Analog Input Functions for first testing

The figure illustrates the minimum elements of a high voltage system.

Revision 1.31