ATZ HDMI-V2-44HE70 Panduan Memulai Cepat - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pengalih Matriks ATZ HDMI-V2-44HE70. ATZ HDMI-V2-44HE70 16 halaman. 4×4 matrix switch over hdbaset™ w/4x hdbaset receiver box 70m, 4k60 4:2:0 hdmi2.0 hdcp2.2

Halaman Cetak

Model

: ATZ HDMI-V2-44HE70

Description : 4×4 Matrix Switch Over HDBaseT™ w/4x HDBaseT Receiver Box 70m,

4K60 4:2:0 HDMI2.0 HDCP2.2

IR Control system

01. At Matrix end: Insert the 3.5mm jacks of the IR TX Emitters included with the unit into the

IR TX Emitter ports at the rear of the matrix according to input. The IR signal is added to the

HDMI of the input device, for example, if the user is watching Blue-ray on input 1, the IR signal

will be directed through the IR TX1 socket to control the device.

As each IR TX port is allocated to an individual HDMI input port, if the user is unable to establish

IR control of the device, care should be taken to check firstly, that the IR emitter and HDMI

input ports match (Input 1-TX1, Input2-TX2 etc.) with plugs secured in correct ports, and

secondly, that the IR TX emitter sensors are firmly attached directly to the front of inputs and

covering infrared sensor windows of the source devices. Some later adjustment may be needed

to the location of the sensor to achieve the best performance results - sometimes moving the

sensor to different areas on the source can improve IR performance.

Notes

: - All brand names and trademarks are properties of their respective holders and are referred to here for descriptive purpose only. Photo attached is for reference only, it may be slightly varied in items of colour,

shape from the actual item delivered from time to time.

(IR Call-back of Matrix and Source Devices)

The matrix is not only a switcher and extender of multiple HDMI

signals to multiple HDMI receivers located remotely, it also

passes IR control signals through the IR call-back system to the

matrix and HDMI sources for full, independent control of all

connected inputs from output locations.

Two-way IR Call-back between matrix, Sources and Displays from

Multiple Locations

A key feature on the matrix is discrete IR control of the matrix,

sources and displays from any location – so inputs at the matrix

end can be controlled at a display location and displays can be

controlled at the matrix location. This is accomplished by placing

a series of IR Emitters on devices to control and IR Receivers at

all locations you wish to control from to enable the IR signal to

travel both ways via the single Cat5e/6/7 cable.

All specifications are subject to change without prior notice.

pg. 8