ATZ HDMI-V2-44HE70 Panduan Memulai Cepat - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pengalih Matriks ATZ HDMI-V2-44HE70. ATZ HDMI-V2-44HE70 16 halaman. 4×4 matrix switch over hdbaset™ w/4x hdbaset receiver box 70m, 4k60 4:2:0 hdmi2.0 hdcp2.2

Halaman Cetak

Model

: ATZ HDMI-V2-44HE70

Description : 4×4 Matrix Switch Over HDBaseT™ w/4x HDBaseT Receiver Box 70m,

4K60 4:2:0 HDMI2.0 HDCP2.2

NOTE: Infrared receiving areas of devices can be located by shining a flashlight onto the front of

the device – the sensor should be able to be seen through the plastic as a small, round object

inside. Insert 3.5mm jacks of IR RX receivers into RX ports, making sure the receivers

themselves are placed in clear view to receive an infrared signal from the remote handset used

to control the display outputs.

02. At display end: Insert the IR RX Receiver jack into the IR RX port of the display receiver

balun, with the receivers themselves placed in clear view on or near the displays to receive an

infrared signal from the remote handset used to control inputs. Insert the IR TX Emitter jack into

the IR TX port of the display receiver balun, ensuring that the emitter sensor is securely

attached to infrared sensor window of the display. Follow the same connection and positioning

for all baluns/displays connected to the matrix. If all IR TX Emitters and IR RX Receivers are

positioned and connected correctly with sources, displays and display receivers fully powered

and the matrix set to IR call-back enabled and IR TX Switch mode activated, two-way IR will

now be possible.

Note: Misplaced or poorly secured IR Emitters and Receivers may result in intermittent IR

control signals passed to and from the matrix. Check your placement and adjust if necessary.

IR BLASTER (TX)

To control the source: Plug IR Blaster into IR OUT port of transmitter unit; place blaster in front

of the IR eye of the source.

To control the display: Plug IR Blaster into IR OUT port of receiver unit; place blaster in front of

the IR eye of the display.

IR RECEIVER (RX)

To control the source: Plug IR Receiver into IR IN port of receiver unit; place receiver at or near

display.

To control the display: Plug IR Receiver into IR IN port of transmitter unit; place receiver in

position where it is able to receive remote signals.

pg. 9

Notes

: - All brand names and trademarks are properties of their respective holders and are referred to here for descriptive purpose only. Photo attached is for reference only, it may be slightly varied in items of colour,

shape from the actual item delivered from time to time.

All specifications are subject to change without prior notice.