Aube Technologies TH106 Panduan Pemilik
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Termostat Aube Technologies TH106. Aube Technologies TH106 8 halaman. Programmable thermostat
Juga untuk Aube Technologies TH106: Panduan Pengguna (3 halaman), Panduan Pemilik (13 halaman), Panduan Pengguna (3 halaman)
Halaman Cetak
TH106, TL6160
Programmable Thermostat
Temperature
preset buttons
Time and day
Set the hour
Set the minute
Set the day
Program the schedule
Skip a period
Select the mode
of operation
Indicates the
heating power
* LP appears only for the first two minutes when the
thermostat is without power. This can occur during a power
outage or when the thermal protection device inside the
baseboard heater is opened.
1. Description
This programmable thermostat can be used to control an
electric heating system such as an electric baseboard heater,
a radiant ceiling, a radiant floor, a convector or a fan-forced
heater.
The thermostat cannot be used with:
• a resistive load over 16.7 A
• a resistive load under 2 A
• a system driven by a contactor or relay (inductive load)
• a central heating system
Indicates that the
temperature setpoint
is displayed
Indicates that the
settings are locked
Temperature
Indicates the current
mode of operation
Temperature
preset icon
Indicates that the
thermostat is
configured for a
fan-forced heater
Indicates the current
period (appears in
Temperature
automatic mode only)
adjustment
Indicates that the ther-
buttons
mostat is without power *
SUPPLIED PARTS:
• One (1) thermostat
• Two (2) 6-32 screws
• Two (2) solderless connectors
2. Installation
TURN OFF POWER TO THE HEATING SYSTEM AT THE MAIN
POWER PANEL TO AVOID ELECTRICAL SHOCK. THE INSTAL-
LATION MUST BE PERFORMED BY AN ELECTRICIAN.
• All cables and connections must conform to the local
electrical code.
• Special CO/ALR solderless connectors must be used
when connecting with aluminum conductors.
• Install the thermostat onto an electrical box.
• Install the thermostat about 5 feet high, or an inside wall
facing the heater.
• Avoid locations where there are air drafts (such as the top
of a staircase or an air outlet), dead air spots (such as
behind a door), or direct sunlight.
• Do not install the thermostat on a wall that conceals
chimney or stove pipes.
• The thermostat wires are not polarized; either wire can be
connected to the load or to the power supply.
NOTE:
Always keep the thermostat's vents clean and unob-
structed.
OWNER'S GUIDE
69-2202-07