DAN NTP TECHNOLOGY DAD THUNDER CORE AX64 Panduan Instalasi - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Peralatan Perekaman DAN NTP TECHNOLOGY DAD THUNDER CORE AX64. DAN NTP TECHNOLOGY DAD THUNDER CORE AX64 19 halaman. Thunderbolt 3, dante, madi and adat modular audio interface
Halaman CetakInstallation of DAD Thunderbolt 3 driver on Windows PC
The driver software has to be installed completely before it can work properly.
When you install the driver, it is of no importance if you have units or other peripherical devices
connected to the Thunderbolt 3 / USB-C port on the computer. In the process descried below there are
no devices connected before installation.
The installation sequence is the following:
1. Copy the driver .msi windows installer file to the computer desk top and double click in order
to start installation
2. Follow the installation instructions click Next and then Install.
3. Once the driver is installed open your audio application and chose the Digital Audio Denmark
ASIO driver
4. In order to configure the ASIO driver open the ASIO dialogue window in the audio
configuration section of your audio application
5. Configuration can be done on the parameters shown in figure 6
Note. The DAD ASIO control panel is accessible as a stand-alone configuration window or if your DAW
audio application supports this, from inside the audio configuration dialogue.
Doc no. AX64-8001-A-4
Figure 5, ASIO driver configuration window.
Rev. date 221023
Page 10 of 19