anytronics Anyscene 512 Panduan Instalasi dan Pengoperasian - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Pengontrol anytronics Anyscene 512. anytronics Anyscene 512 13 halaman. Scene recall unit

Halaman Cetak

7. Programming

7.1. Single Anyscene 512

As supplied, the Anyscene 512 scene memories have a range of saved presets allowing

electrical contractors to confirm correct operation before final commissioning of the

system. They can be easily programmed from any source of DMX data including another

Anytronics scene memory, DMX lighting desk or a computerised lighting system.

Anyscene 512 should be programmed whilst connected into the final installation and the

programming source should be connected into the system.

a) Turn the MWP DIL switch to 'OFF'

b) Connect the DMX programming source (DMX Desk etc.) into the system

c) Power the DMX programming source

d) Power the Anyscene 512, the power and yellow data LED should be lit

e) Use the DMX programming source to adjust the required channels

f) Press and hold the button on the Anyscene 512 where the current scene should

be saved

g) The Anyscene 512 data LED will flash twice to show the data has been saved.

h) Repeat e) to g) for all required scenes

Once all scenes have bee saved turn the MWP DILL 'ON' to protect the recently

programmed scenes

Note: To access scenes 8 to 15 the down button should be held before the scene number

is pressed. To access scenes 16 to 22 the up button should be held before the scene

number is pressed.

Note: that unless the data LED is illuminated, and unless the internal MWP DIL switch is

in the OFF position, no programming of the scenes will be possible.

7.2. Multiple Anyscene 512

When programming a multi Anyscene 512 installation each unit should be connected into

the system individually and then programmed using the sequence of 7.1.

If all Anyscene 512 are to be programmed the same the following procedure should be

followed,

a) Program the

b) Keep the

first unit

c) Ensure the MWP of the

d) Recall the required scene on the

e) Press and hold the required scene location on the

f) The data LED on the

g) Repeat d) to f) for all scenes

h) Remove the

to 'ON'

Repeat b) to h) for all subsequent Anyscene 512

Units 5 & 6 Hillside Industrial Estate

London Road, Horndean,

Hampshire, PO8 0BL

Tel +44 (0)23 9259 9410

Fax +44(0)23 9259 8723

first unit

as per section 7.1

powered and then insert the

second unit

first unit

second unit

from the system and turn MWP DIL switch for that unit

Page 10 of 13

second unit

is off

second unit

should flash twice

Anyscene 512 Operating

The

into the system

AT1039 Issue 1

Instructions