Anywave Marble PA-U-1200-D-FB Panduan Memulai Cepat - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pemancar Anywave Marble PA-U-1200-D-FB. Anywave Marble PA-U-1200-D-FB 18 halaman.

192.168.1.143 – you can change the exciter IP address by navigating to the

CONFIG submenu (simultaneously press Left and Right buttons) and change the

value of IP (please reference your Exciter User Manual for details).

18) If using the Exciter Built-in remote web interface for remote control, please be sure

to set the Exciter to REMOTE mode (set CTL to RMT) before leaving the

transmitter site. The Remote/Local setting is located under the SYSTEM submenu.

Most of the Local TX controls are available on the remote web interface, including

On/Off, Raise/Lower power, etc. (refer to the Exciter user manual for details). For

the PA, it is similar that you can set the PA to REMOTE mode via its web interface

(SYSTEM SETTINGS->HARDWARE-PARA->CTRL-MODE->REMOTE) or

change it via the local touch screen before leaving the transmitter site, as shown

below.

Mable 4Device Quick Start Guide, 5/19/2022

Marble 4Device Quick Start Guide

Page 16 of 18