- ページ 16

送信機 Anywave Marble PA-U-1200-D-FBのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Anywave Marble PA-U-1200-D-FB 18 ページ。

ページを印刷する
Anywave Marble PA-U-1200-D-FB クイック・スタート・マニュアル
192.168.1.143 – you can change the exciter IP address by navigating to the
CONFIG submenu (simultaneously press Left and Right buttons) and change the
value of IP (please reference your Exciter User Manual for details).
18) If using the Exciter Built-in remote web interface for remote control, please be sure
to set the Exciter to REMOTE mode (set CTL to RMT) before leaving the
transmitter site. The Remote/Local setting is located under the SYSTEM submenu.
Most of the Local TX controls are available on the remote web interface, including
On/Off, Raise/Lower power, etc. (refer to the Exciter user manual for details). For
the PA, it is similar that you can set the PA to REMOTE mode via its web interface
(SYSTEM SETTINGS->HARDWARE-PARA->CTRL-MODE->REMOTE) or
change it via the local touch screen before leaving the transmitter site, as shown
below.
Mable 4Device Quick Start Guide, 5/19/2022
Marble 4Device Quick Start Guide
Page 16 of 18