Anywave PA-U-2200-D-FB Marble Panduan Memulai Cepat - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pemancar Anywave PA-U-2200-D-FB Marble. Anywave PA-U-2200-D-FB Marble 18 halaman.

Below is an example photo showing the system connections. (Please note: this photo is

illustrative only and your system connections may differ slightly. Please refer to the

system diagram above for the specific system interconnection for your 2KW system).

4 Initial Turn On

Please locate and have handy for reference a copy of your Factory Test Report as

well as the Quick Start Guide, and PA and Exciter User Manuals.

1) With all equipment turned OFF, please make the cable connections according to the

System Interconnect Diagram of section 3. Make sure the BPF or PA output is

properly connected to your Antenna feed or a suitable station load before

proceeding further.

2) Turn ON the Exciter via its rear-panel AC switch.

3) Check Exciter settings. Check the operating Frequency of the Exciter by navigating

to the Exciter FREQ submenu (simultaneously press Left and Right buttons)

Mable 8Device Quick Start Guide, 5/19/2022

Marble 8Device Quick Start Guide

Page 8 of 18