Anywave PA-U-2200-D-FB Marble 빠른 시작 매뉴얼 - 페이지 8
{카테고리_이름} Anywave PA-U-2200-D-FB Marble에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anywave PA-U-2200-D-FB Marble 18 페이지.
Below is an example photo showing the system connections. (Please note: this photo is
illustrative only and your system connections may differ slightly. Please refer to the
system diagram above for the specific system interconnection for your 2KW system).
4 Initial Turn On
Please locate and have handy for reference a copy of your Factory Test Report as
well as the Quick Start Guide, and PA and Exciter User Manuals.
1) With all equipment turned OFF, please make the cable connections according to the
System Interconnect Diagram of section 3. Make sure the BPF or PA output is
properly connected to your Antenna feed or a suitable station load before
proceeding further.
2) Turn ON the Exciter via its rear-panel AC switch.
3) Check Exciter settings. Check the operating Frequency of the Exciter by navigating
to the Exciter FREQ submenu (simultaneously press Left and Right buttons)
Mable 8Device Quick Start Guide, 5/19/2022
Marble 8Device Quick Start Guide
Page 8 of 18