Anywave PA-U-2200-D-FB Marble 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} Anywave PA-U-2200-D-FB Marble에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anywave PA-U-2200-D-FB Marble 18 페이지.

Check the Exciter drive level is set to -25dBm by navigating to the Exciter RF

submenu (from above, press the ESC button then enter the RF submenu).

(Please refer to your Exciter User Manual for help with the detailed operation of the

Exciter).

4) Turn the PA AC mains ON via the PA rear panel breaker and make sure that the PA

RF-Switch is set to OFF on the System Settings tab (PA is turned off).

5) If you are changing channels, please be sure that the Marble PA is calibrated for the

proper channel (otherwise, the PA built-in power meters will not read correctly and

may cause false trips or damage to the equipment – and void the equipment

warranty).

Please be sure that the Marble PA-to-Exciter serial cable is properly connected (as

shown in the above system interconnect diagram) with the RS-232-to-485 adapter

Mable 8Device Quick Start Guide, 5/19/2022

Marble 8Device Quick Start Guide

Page 9 of 18