Duerkopp Adler 195 Panduan Instalasi - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Mesin Jahit Duerkopp Adler 195. Duerkopp Adler 195 14 halaman.
Juga untuk Duerkopp Adler 195: Panduan Petunjuk Pengoperasian (18 halaman)

Halaman Cetak

5.1 Fitting oil recycling device

9. Setting the Synchronizer

The oil recycling device collects the oil in the oil

sump and returns it by apump to the oil circuit.

–

Wrap intake filter 3 of the oil recycling device

by the felt and fasten it to the oil sheet by the

clamp 2.

–

Install the oil hose 1 and secure it so that it

cannot get into contact with mobile parts.

ATTENTION !

Change the oil every 2 years, irrespective of the

number of operating hours.

The machine positions are seen by the

synchronizer in steps (increments) of 0.7° and

shown in the display. A complete revolution

corresponds to 512 steps.

1st Position

The machine should stop when the hook has

securely taken up the loop.

This means that the needle should raise above its

lower dead center until the hook tip has moved

approx. 6 mm above the needle to the left. This

corresponds to the increment number 50.

2nd Position

Needle bar a little bit before the upper dead center.

This corresponds to the increment number 190.