Duerkopp Adler 743-121 Panduan Petunjuk Pengoperasian - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Mesin Jahit Duerkopp Adler 743-121. Duerkopp Adler 743-121 14 halaman.
Juga untuk Duerkopp Adler 743-121: Panduan Petunjuk Instalasi (7 halaman)
Halaman Cetak
2.9 Positioning the Sewing Pieces
2.10 Sewing
14
–
Mark the dart depth on the fold plate 1 with thinnest possible
smooth adhesive tape.
–
Place the sewing piece over the edge of the fold plate with both
hands.
–
Bring the cut edges together with the right hand so that the edges
match.
–
Align the small hole for the dart length precisely at the back edge
of the fold plate.
–
Hold the material in place at the front edge with the right hand and
push in the fold plate.
The material is held in place by the configuration set.
The fold plate runs to the back.
The sewing procedure is carried out.
After the main switch is turned on or the
" STOP " button is pushed, the microcomputer checks the initial
settings of the machine.
The needle is brought to its initial position.
If no fault is found the " <--- REF ---> " or "
appear.
This means that the configuration set must be run to the reference
point.
Press the "
" button.
The configuration set travels to the reference point.
Starting sewing
–
Insert material.
–
Push in the folding table with the material.
The sewing cycle starts.
CAUTION !
Do not push in the folding table without material !
The friction surface of the configuration set could be damaged.
1
REF ---> " display will