Dugena 762 Buku Petunjuk & Jaminan - Halaman 10

Jelajahi secara online atau unduh pdf Buku Petunjuk & Jaminan untuk Jam Alarm Dugena 762. Dugena 762 15 halaman. Radio-controlled solar alarm clock movement
Juga untuk Dugena 762: Buku Petunjuk & Jaminan (17 halaman)

Halaman Cetak

4. Radio technology

Radio technology is the most modern form of time transmission. With good recep-

tion, a radio-controlled clock keeps very precise time and need never be reset.

With all radio-controlled clocks a deviation of just 1 second over 1 million years

can be expected. The official German transmitter is in the vicinity of Frankrut/Main

and transmits via long wave 77,5 kHz within a radius of approx. 1,500 km.

5. Setting up

The rechargeable battery is already inserted, only the protective foil has to be

removed. Open the battery compartment cover (4) (backside) and pull out the foil.

The energy produced by the solar module is stored in the special battery. This

is done even in average light conditions. Please note that when the alarm is not

exposed to light, the life of the battery will be reduced because of the exposure to

light. If the power decreases (for example, lighting becomes weaker), expose it to

direct sunlight for several hours to recharge the battery.

6. Setting the time automatically

After that, the receiver is switched off. During the reception phase, lasting approx.

2 minutes, the hands stay at the 12 o'clock position. The entire procedure for

setting the hands to exact time takes up to 9 minutes. When you insert the

battery, please never hold down the top button (1). If in doubt, repeat the start-up

procedure.

7. Setting the alarm time

To set the alarm time you require, turn the adjusting knob (3) on the back of the

alarm clock in the direction indicated by the arrow. If you turn the knob in the

opposite direction this will not always adjust the alarm hand. To activate the alarm

function, push the side-mounted switch (2) upwards towards the bell symbol. The

green panel appears at the switch.

8. Switching off the alarm time signal / Snooze (alarm repetition)

Using the snooze/illumination button at the top (1) Press the snooze (alarm

repetition) button briefly. The alarm signal is interrupted for 4 to 5 minutes and

then begins again. If the alarm signal is not interrupted or switched off, it stops

automatically after approx. 2 minutes. It will then sound again 12 hours later at

the set alarm time. Snooze operation can be repeated any number of times for a

period of approx. 60 minutes. To deactivate the alarm function completely, press

the side-mounted switch-off button (2) down.

9. Illumination

Your alarm clock's dial light is switched on automatically for 5 seconds each time

the alarm goes off. The dial is also lit for 5 seconds whenever you briefly press

the top button.