Abtus AV544 Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Rak dan Dudukan Abtus AV544. Abtus AV544 2 halaman. Lcd / led display wall mount

Halaman Cetak

User Operation Guide

PACKAGING CONTENT

Item

Wall Mount

1 set

1). Do not begin the installation of this product until you have read and fully understood the instructions

and warnings contained in this installation sheet. If you have any questions regarding any of the instruction

or warning, please contact your local distributor.

2). Please refer to the manufacturer's installation guide on recommendation for required distance from

the wall to avoid risk of property damage.

3) This product should only be installed by someone when good mechanical knowledge.

4). Make sure that the supporting surface can safely support the combined load of the equipment and all

attached hardware an components.

5). Never exceed the Maximum Local Capacity.

6). When mounting onto wooden wall studs, ensure that mounting screws are anchored into the center

of the studs Use of an "edge to edge" stud finder is highly recommended.

7). This product intended for indoor use only. Installing this product outdoors could lead to product failure

and personal injury.

** For detail, updated Command Code and Application Software, please visit and download from www.abtussingapore.com

Bolt M5x16

4 sets

Bolt M8x16

4 sets

Lag bolt St5x40

3 sets

Concrete anchor 8x40

3 sets

Item

TV Bracket

WARNING

1). Do not over tighten screws during installation. Over tightening can cause damage to the

screws and greatly reduce their ability to support the weight of the display.

2). Ensure that the mounting screws are anchored to the center of studs. Use of

an "edge to edge" stude finder is highly recommended.

Step 1:

Drill holes onto the wall and put 8x40 Concrete anchor

(E) in the holes. Fit the wall board to the wall using ST5X40

Lag bolt (D) as above / right fig.

Keep the bubble level aline.

1 set

Step 2: Mounting the TV set to the TV board

Using A-C bolt packed in accessories package, mount the screen to the TV board.

Put in the screws (A-C), then fix them to the TV mounting holes as shown below.

Step 3: Putting the wall mounted TV board

with screen to the wall board

Hand the TV set mounted on the TV board (G) to the

wall board (F). Please see as right fig.

INSTALLATION

* Specifications are subject to changes without notice.