Abtus AV544 사용자 설명서 - 페이지 2

{카테고리_이름} Abtus AV544에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Abtus AV544 2 페이지. Lcd / led display wall mount

User Operation Guide
PACKAGING CONTENT
Item
A
C
Item
D
Item
E
Item
F
Wall Mount
1 set
1). Do not begin the installation of this product until you have read and fully understood the instructions
and warnings contained in this installation sheet. If you have any questions regarding any of the instruction
or warning, please contact your local distributor.
2). Please refer to the manufacturer's installation guide on recommendation for required distance from
the wall to avoid risk of property damage.
3) This product should only be installed by someone when good mechanical knowledge.
4). Make sure that the supporting surface can safely support the combined load of the equipment and all
attached hardware an components.
5). Never exceed the Maximum Local Capacity.
6). When mounting onto wooden wall studs, ensure that mounting screws are anchored into the center
of the studs Use of an "edge to edge" stud finder is highly recommended.
7). This product intended for indoor use only. Installing this product outdoors could lead to product failure
and personal injury.
** For detail, updated Command Code and Application Software, please visit and download from www.abtussingapore.com
Bolt M5x16
4 sets
Bolt M8x16
4 sets
Lag bolt St5x40
3 sets
Concrete anchor 8x40
3 sets
Item
G
TV Bracket
WARNING
1). Do not over tighten screws during installation. Over tightening can cause damage to the
screws and greatly reduce their ability to support the weight of the display.
2). Ensure that the mounting screws are anchored to the center of studs. Use of
an "edge to edge" stude finder is highly recommended.
Step 1:
Drill holes onto the wall and put 8x40 Concrete anchor
(E) in the holes. Fit the wall board to the wall using ST5X40
Lag bolt (D) as above / right fig.
Keep the bubble level aline.
1 set
Step 2: Mounting the TV set to the TV board
Using A-C bolt packed in accessories package, mount the screen to the TV board.
Put in the screws (A-C), then fix them to the TV mounting holes as shown below.
Step 3: Putting the wall mounted TV board
with screen to the wall board
Hand the TV set mounted on the TV board (G) to the
wall board (F). Please see as right fig.
INSTALLATION
* Specifications are subject to changes without notice.