Danfoss iC7 Series Panduan Instalasi - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Penggerak DC Danfoss iC7 Series. Danfoss iC7 Series 16 halaman. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Juga untuk Danfoss iC7 Series: Panduan Instalasi (8 halaman), Panduan Instalasi (8 halaman), Panduan Instalasi (6 halaman), Panduan Instalasi (14 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (8 halaman), Panduan Instalasi (8 halaman), Panduan Instalasi (10 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (6 halaman), Panduan Instalasi (6 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (18 halaman)

In-back/Out-top Cooling Kit for FA09-FA10

Installation Guide

Secure the grill to the duct frame using 1 M5 nut on each stud.

Torque to 2.3 Nm (20 in-lb).

Affix the grill gasket to the outer side of the back grill.

Affix the duct base gasket to the duct base cover.

Secure the base cover to the underside of the duct frame with 12 M5 nuts (for FA09) or 14 M5 nuts (for FA10).

Torque to 2.3 Nm (20 in-lb).

Place the front gasket on the front side of the duct frame, making sure the holes in the frame and gasket align.

Affix the top gasket to the top of the duct frame.

Wait to attach the front duct cover until the lower duct assembly is installed in the cabinet.

Illustration 12: Assembly of Lower Duct

Top gasket

Front gasket

M5 nut

Front cover

Grill gasket

2.10 Installing the Lower Duct

To attach the lower duct to the frequency converter, use the following steps.

Procedure

Place the strip gasket over the 2 slots at the bottom back of the frequency converter.

Back grill

Side gaskets, left and right

Duct frame

Base gasket

Duct base cover

AN371942666355en-000101 / 136R0250

Installation