Casio 2411 Manual

Jelajahi secara online atau unduh pdf Manual untuk Menonton Casio 2411. Casio 2411 9 halaman.

Halaman Cetak

Module No. 2411

GETTING ACQUAINTED

Congratulations upon your selection of the CASIO Wrist Camera (this watch).

To get the most out of your purchase, be sure to read this manual carefully,

and keep the manual and everything contained in the package on hand.

About This Manual

' ‰ 1 6 - 3 ‰

SAT

1 ‰ : 5 8

• Each section of this manual provides you with the information you need to

perform operations in each mode. Further details and technical information

can be found in the "REFERENCE" section.

• VISUAL DATABANK is a trademark of CASIO COMPUTER CO., LTD.

• Ir data communication uses Phoenix Technologies Ltd., protocol

• CASIO COMPUTER CO., LTD. assumes no responsibility for any loss,

or any claims by third parties that may arise through the use of this

watch.

Warning!

• • • • • Make sure you are in a safe place before operating the watch.

Do not try to record images, perform complex watch operations, or look at the

display of the watch while operating an automobile, motorcycle, or any other

vehicle. Doing so creates the risk of serious traffic accident. When you use

the watch while walking, always keep aware of other people, vehicular traffic,

and surface conditions around you in order to prevent accidents.

• • • • • Do not use the watch inside of an aircraft.

Never use the watch inside of an aircraft or in any other area where the use

of such devices is prohibited. Doing so creates the risk of accident.

• • • • • Always back up important data.

Rough handling of or damage to the watch can accidentally delete image

data in watch memory. Because of this, you should always keep back up

copies of your images on computer disk.

BEFORE USING THE WATCH...

To set the time and date

' ‰ 1 6 - 3 ‰

SAT

1 ‰ : 5 8

Press

Seconds

Hour

Wake up

Image Setting

2. While a setting is flashing, use E (+) and B (–) to change it.

• Holding down either button scrolls at high speed.

• Pressing D while the day is flashing on the setting screen causes the

indicator for the current timekeeping format (12H or 24H) to flash on the

display. Each press of E at this time toggles between 12-hour (12H)

and 24-hour (24H) timekeeping.

3. When everything is the way you want it, press A to exit the setting

screen.

• The day of the week is set automatically in accordance with the date

setting.

• See "To adjust the display contrast" for more information about the

contrast setting.

• See "To specify the wake up screen image" for more information about

the wake up image setting.

• Button operations are indicated using the

letters shown in the illustration.

• The sizes and positions of the characters

shown on the sample displays in this

manual may differ slightly from those that

actually appear on the display of your

watch.

• When performing operations with this

watch, you must first enter the correct mode

(Camera Mode, Timekeeping Mode, etc.)

See "GENERAL GUIDE" for information

about maneuvering between modes.

1. In the Timekeeping Mode, hold down A

for about one second until the second's

digits start to flash on the display, which

indicates the setting screen.

• Use C and D to cycle around the

setting screen in the sequence shown

below.

Press

Minutes

Year

Contrast

12/24-hour

Setting

Selection

To adjust the display contrast

Auto Power Save

' ‰ 1 6 - 3 ‰

1 ‰ : 5 8

About the wake up screen

The wake up screen appears for about two seconds when you recover from

the auto power save. You can use the procedure under "To specify the wake

up screen image" to specify an image you recorded as the wake up screen

image.

• "CASIO" flashes on the wake up screen if you do not have any wake up

screen image specified or if the image you specified has been deleted.

Month

Day

1. In the Timekeeping Mode, hold down A

for about one second.

2. Press C twice to display the contrast

CNT

adjustment screen.

• The contrast setting shows a value that

indicates the current contrast level. A

setting of Level 3, for example, is

indicated as CNT3.

3. Use B (darker) and E (lighter) to adjust

the contrast to any one of the nine

available levels.

4. Press A to exit the setting screen.

Note

The contrast setting described above does not

affect the display of images. Image contrast

can be adjusted using a separate procedure,

which is described in "To adjust image

brightness".

The watch automatically turns off its display

screen if it is not moved for about 60 minutes.

This not only conserves battery power, it also

protects against "burn in" of display images.

SAT

To turn the display back on, press F .

This displays the wake up screen image for

about two seconds, and then displays the

Timekeeping Mode screen.

2411-1