Danfoss ECL Comfort 310 Panduan Servis - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Servis untuk Termostat Danfoss ECL Comfort 310. Danfoss ECL Comfort 310 16 halaman. A302
Juga untuk Danfoss ECL Comfort 310: Panduan Instalasi (8 halaman), Manual Pemasangan (4 halaman), Panduan Pengguna (12 halaman), Panduan Pengguna (12 halaman), Panduan Instalasi (4 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (20 halaman), Panduan Pengoperasian (8 halaman), Panduan Pengoperasian (16 halaman), Panduan Pengoperasian (10 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (7 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (12 halaman), Manual Pemasangan (20 halaman), Manual Pemasangan (20 halaman), Manual Pemasangan (12 halaman), Manual Pemasangan (16 halaman), Panduan Pengoperasian (8 halaman)

Danfoss ECL Comfort 310 Panduan Servis
Service guide

2.0 Introduction

In smaller district heating networks ligthning can be a challenge for
the connected devices like ECL Comfort 296 / ECL 310 controllers.
If not protected, Modbus interfaces are subject for being burned in
case of lightning.
Based on several market inputs and analysis we identified a need for
information.
This has resulted in the present service guide which includes
recommendations for new installations.
The document is prepared in compliance with www.modbus.org

3.0 Conclusion

1. Each nodes in the "Modbus network" (central heating station,
repeater station or individual house) are highly recommended
to have "surge protector". It must be selected as per section 6
and installed as described in section 7.
2. Phoenix "PT 1X2+F-BE" (or similar products from another manu-
facturer, as per the surge protection requirement in section 6)
must be used instead of "PT 1X2-BE" in individual house installa-
tions. Refer section 8.
3. Recommendation on Modbus reference common signal con-
nection, shield connection, termination resistor connection may
be referred in section 5, 6, 7 and 8.
2 | © Danfoss| 2017.06
ECL 296 / ECL 310 Modbus
VI.LV.H1.02