Danfoss ECL Comfort 310 Panduan Servis - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Servis untuk Termostat Danfoss ECL Comfort 310. Danfoss ECL Comfort 310 16 halaman. A302
Juga untuk Danfoss ECL Comfort 310: Panduan Instalasi (8 halaman), Manual Pemasangan (4 halaman), Panduan Pengguna (12 halaman), Panduan Pengguna (12 halaman), Panduan Instalasi (4 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (20 halaman), Panduan Pengoperasian (8 halaman), Panduan Pengoperasian (16 halaman), Panduan Pengoperasian (10 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (7 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (12 halaman), Manual Pemasangan (20 halaman), Manual Pemasangan (20 halaman), Manual Pemasangan (12 halaman), Manual Pemasangan (16 halaman), Panduan Pengoperasian (8 halaman)

Service guide

4.0 Modbus network definitions

The below drawing gives a general overview of the serial bus

infrastructure in a Modbus multipoint serial line system.

1) = surge protector

The following conventions are adopted in the figure above:

1. The interface with the trunk is named ITr (Trunk Interface)

2. The interface between the device (ECL 296 / 310) and the

Passive Tap ( surge protector) is named IDv (Derivation

Interface)

3. The interface between the device (ECL 296 / 310) and the

Active Tap (repeater) is named AUI (Attachment Unit Interface)

4. LT = line termination. Resistor: 120 ohm , 0,5 W or 150 ohm,

0,5 W

A multipoint Modbus serial line bus is made of a principal cable

(the trunk) and possibly some derivation cables.

Line terminations are necessary at each extremity of the trunk

cable for impedance adaptation.

VI.LV.H1.02

ECL 296 / ECL 310 Modbus

2) = repeater