Danfoss living connect Instalasi dan Panduan Pengguna - Halaman 7
Jelajahi secara online atau unduh pdf Instalasi dan Panduan Pengguna untuk Termostat Danfoss living connect. Danfoss living connect 16 halaman. Z-wave certified electronic radiator
thermostat
Juga untuk Danfoss living connect: Instalasi dan Panduan Pengguna (20 halaman), Lembar data (8 halaman)
Halaman Cetak
Installation Guide
Adapter for RTD valves (accessory)
1.
Place the RTD adapter on the valve as shown.
Adapters for M28 valves (accessories)
Please follow the instructions supplied with the valve adapter for the specific M28 valve.
1.5 Inserting the batteries
Remove the battery cover and insert two AA batteries. Make sure the
batteries are correctly oriented.
Rechargeable batteries must not be used.
When replacing batteries the programme settings will be preserved,
but after two minutes the settings for time and date are reset.
The low battery symbol
batteries run out.
After approx. two weeks the
to 21:00 hrs.
Before the batteries run out living connect® will leave the valve in a
slightly open position to protect the valve from damage.
1.6 Using the buttons
living connect® has two arrow buttons
the display and the menus and to set the temperature*.
The dot button
is used to select and confirm.
If the display is off, press either button to activate the display.
*The temperature is usually controlled via Danfoss Link™ CC, but may be
changed at any time using the thermostat's buttons. If this is done, the
thermostat sends a message to Danfoss Link™ CC, instructing it to synchro-
nise the other thermostats in the same room.
Danfoss Heating Solutions
living connect®
is displayed approx. one month before the
symbol will flash 14 times from 19:00
which allow you to navigate
VIIDH102
2.
Hand-tighten the RTD adapter (max. 5 Nm).
7
11/2013