Danfoss living connect Instalasi dan Panduan Pengguna - Halaman 8
Jelajahi secara online atau unduh pdf Instalasi dan Panduan Pengguna untuk Termostat Danfoss living connect. Danfoss living connect 16 halaman. Z-wave certified electronic radiator
thermostat
Juga untuk Danfoss living connect: Instalasi dan Panduan Pengguna (20 halaman), Lembar data (8 halaman)
Halaman Cetak
Installation Guide
1.7 Installing living connect®
1.
living connect® must be in Installation Mode
to be fixed correctly onto the valve. This is
indicated by a large, flashing M in the display.
Installation Mode can be selected by pressing
for 3 seconds until M is displayed, then
release and press
3.
to fix living connect®.
Press
1.8 Automatic adjustments
During the first night of operation living connect® will shut off the radiator heat and then open
again to detect the exact opening point of the valve. This will allow living connect® to control the
heat as efficiently as possible. If necessary, the proce dure is repeated once a night for up to a week.
You might experience the valve being warm dur ing the adjustment procedure, regardless of the
room temperature.
Intelligent Control (Forecast)
During the first week of operation living connect® learns when it is necessary to start heating the
room in order to reach the correct temperature at the correct time.
The intelligent control will continuously adjust the heating time compared to seasonal tempera-
ture changes.
Using Saving Program requires that your heating system has enough heat for a short period during
heat up. If your experience problems you should contact your installer.
8
11/2013
living connect®
again.
2.
Screw living connect® onto the adapter and
tighten by hand (max. 5 Nm).
While slightly pressing forward, turn living
connect® clockwise untill it locks, then tighten.
4.
Icons for Network Connection and Alarm are
flashing, indicating living connect® is ready for
connection with Danfoss Link™ CC.
VIIDH102
Danfoss Heating Solutions