Danfoss living connect 설치 및 사용자 설명서 - 페이지 8

{카테고리_이름} Danfoss living connect에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss living connect 16 페이지. Z-wave certified electronic radiator thermostat
Danfoss living connect에 대해서도 마찬가지입니다: 설치 및 사용자 설명서 (20 페이지), 데이터시트 (8 페이지)

페이지 인쇄

Installation Guide

1.7 Installing living connect®

living connect® must be in Installation Mode

to be fixed correctly onto the valve. This is

indicated by a large, flashing M in the display.

Installation Mode can be selected by pressing

for 3 seconds until M is displayed, then

release and press

to fix living connect®.

Press

1.8 Automatic adjustments

During the first night of operation living connect® will shut off the radiator heat and then open

again to detect the exact opening point of the valve. This will allow living connect® to control the

heat as efficiently as possible. If necessary, the proce dure is repeated once a night for up to a week.

You might experience the valve being warm dur ing the adjustment procedure, regardless of the

room temperature.

Intelligent Control (Forecast)

During the first week of operation living connect® learns when it is necessary to start heating the

room in order to reach the correct temperature at the correct time.

The intelligent control will continuously adjust the heating time compared to seasonal tempera-

ture changes.

Using Saving Program requires that your heating system has enough heat for a short period during

heat up. If your experience problems you should contact your installer.

11/2013

living connect®

again.

Screw living connect® onto the adapter and

tighten by hand (max. 5 Nm).

While slightly pressing forward, turn living

connect® clockwise untill it locks, then tighten.

Icons for Network Connection and Alarm are

flashing, indicating living connect® is ready for

connection with Danfoss Link™ CC.

VIIDH102

Danfoss Heating Solutions