Danfoss VLT AQUA Drive FC 202 Panduan Petunjuk Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Unit Kontrol Danfoss VLT AQUA Drive FC 202. Danfoss VLT AQUA Drive FC 202 6 halaman. Igbt module replacement for d1h–d8h drives
Juga untuk Danfoss VLT AQUA Drive FC 202: Panduan Pengoperasian (16 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (18 halaman), Panduan Petunjuk Instalasi (8 halaman), Panduan Petunjuk Instalasi (10 halaman), Panduan Instalasi (6 halaman), Panduan Petunjuk Pengoperasian (16 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Instalasi (8 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Instalasi (8 halaman), Panduan Instalasi (6 halaman)

Halaman Cetak
Danfoss VLT AQUA Drive FC 202 Panduan Petunjuk Instalasi
8.
Unscrew the 2 T10 screws holding the control card
EMC shield (4 screws if MCO is installed).
8a
If MCO is installed, remove the MCO ribbon
cable.
9.
Remove the control card EMC shield.
1
T10 screws
2
EMC shield
Illustration 1.7 Screws and EMC Shield
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on
order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks in this material are property of the respective companies. Danfoss
and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
Danfoss A/S
Ulsnaes 1
DK-6300 Graasten
vlt-drives.danfoss.com
130R0788
1
2
Re-assemble the new control card in reverse order.
MI93A102
*MI93A102*
10.
Unscrew the 3 T10 screws and remove them.
11.
Gently remove the control card from the upper-right
socket. Avoid overbending and contact with
electronic components.
Control card
T10 screws
Illustration 1.8 Control Card and T10 Screws
03/2017