Audiolab EDGE 12 sub Panduan Pengguna - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Subwoofer Audiolab EDGE 12 sub. Audiolab EDGE 12 sub 19 halaman. Self-powered 12 "subwoofer with a 3.5" voice coil
Halaman Cetak5. WIRE CONNECTIONS
Either the 1/4" TRS phone jack or XLR connector can be wired in balanced and unbalanced modes, which
will be determined by the actual application status, please wire your system as the following wiring
examples:
For 1/4" Phone jack
Tip
Sleeve
TS Type Unbalanced
For XLR connector
Pin 1
XLR Type Unbalanced
The series speaker connections are made via
the rear panel 1/4" and/or Speakon connectors
for easy interface with industry standard cables.
Standard, unshielded speaker wire (available at
your local pro audio or music store), with either
1/4" phone or Speakon connectors and wire gauge
of 12-14 AWG is recommended.
If your amplifier uses binding posts you can use
speaker cables with banana connectors, but be
P. 8
AUDIOLAB EDGE 12 sub -
English version
Ring
TRS Type Balanced
Pin 2 (+)
Pin 3 (-)
(Linked to Pin 1 manually)
Tip
Sleeve
Pin 3 (-)
XLR Type Balanced
sure to pay attention to the +/- polarity when mak-
ing the connections. Make sure that the + terminal
of the speaker, or banana connector, is connected
to the+ terminal of the power amplifier, and that
the - terminal of the speaker, or banana connector,
is connected to the - terminal of the power ampli-
fier. It is important that your PA system is con-
nected in-phase, otherwise you will not have the
proper low-end response and stereo image.
Tip
Ring
Sleeve
TRS Type Unbalanced
Pin 2 (+)
Pin 1