Audiolab EDGE 12 sub 사용자 설명서 - 페이지 8

{카테고리_이름} Audiolab EDGE 12 sub에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiolab EDGE 12 sub 19 페이지. Self-powered 12 "subwoofer with a 3.5" voice coil

페이지 인쇄

5. WIRE CONNECTIONS

Either the 1/4" TRS phone jack or XLR connector can be wired in balanced and unbalanced modes, which

will be determined by the actual application status, please wire your system as the following wiring

examples:

For 1/4" Phone jack

Tip

Sleeve

TS Type Unbalanced

For XLR connector

Pin 1

XLR Type Unbalanced

The series speaker connections are made via

the rear panel 1/4" and/or Speakon connectors

for easy interface with industry standard cables.

Standard, unshielded speaker wire (available at

your local pro audio or music store), with either

1/4" phone or Speakon connectors and wire gauge

of 12-14 AWG is recommended.

If your amplifier uses binding posts you can use

speaker cables with banana connectors, but be

P. 8

AUDIOLAB EDGE 12 sub -

English version

Ring

TRS Type Balanced

Pin 2 (+)

Pin 3 (-)

(Linked to Pin 1 manually)

Tip

Sleeve

Pin 3 (-)

XLR Type Balanced

sure to pay attention to the +/- polarity when mak-

ing the connections. Make sure that the + terminal

of the speaker, or banana connector, is connected

to the+ terminal of the power amplifier, and that

the - terminal of the speaker, or banana connector,

is connected to the - terminal of the power ampli-

fier. It is important that your PA system is con-

nected in-phase, otherwise you will not have the

proper low-end response and stereo image.

Tip

Ring

Sleeve

TRS Type Unbalanced

Pin 2 (+)

Pin 1