3Ware 3WARE 9650SE Spesifikasi - Halaman 7

Jelajahi secara online atau unduh pdf Spesifikasi untuk Multiplexer 3Ware 3WARE 9650SE. 3Ware 3WARE 9650SE 7 halaman. Remote battery board
Juga untuk 3Ware 3WARE 9650SE: Adendum Panduan Pengguna (1 halaman), Panduan Pengguna (11 halaman), Panduan Instalasi (4 halaman)

Halaman Cetak
Using the AMCC 3ware® I2C Multiplexer with a Supermicro® Backplane
Jumper Settings for Supermicro 846TQ
Table 5: Reset Chip Settings
These jumpers control the AMI 9072 chips
Jumper
Jumper Settings
JP35
Open: No Reset (Default)
Closed: Reset
JP50
Open: No Reset (Default)
Closed: Reset
JP129
Open: No Reset (Default)
Closed: Reset
Table 6: I2C Setting (Default)
This jumper controls the I2C and SGPIO settings for the 846TQ
Jumper
Jumper Settings
JP84
2-3
Copyright ©2008 Applied Micro Circuits Corporation (AMCC). All rights reserved. 3ware® and 3DM® are registered trademarks of AMCC. The 3ware logo, 3BM, StorSave are
all trademarks of AMCC. Supermicro® is a registered trademark of Supermicro Computer, Inc. All other trademarks herein are property of their respective owners.
While every attempt is made to make this document as accurate as possible, AMCC assumes no responsibility for errors or omissions in the document and shall not be responsible
or liable for any and all damages, claims and/or disputes that arise from dependence on this publication.
www.3ware.com
Note
This is a 2-pin jumper block.
Jumper should be removed.
This is a 2-pin jumper block.
Jumper should be removed.
This is a 2-pin jumper block.
Jumper should be removed.
Note
Jumper should connect pins 2 and 3.
Cable Pin Definitions
Table 7: Cable pins - I2C MUX to 9650SE or 9550SXU
2
Signal
3ware 9650SE or 9550SXU
I
C MUX
Reset (SB4)
Pin 3
Pin 3
Ground (SB2)
Pin 4
Pin 4
SDA (SB1)
Pin 5
Pin 5
Ground (SB3)
Pin 6
Pin 6
SCL (SB0)
Pin 7
Pin 7
IRQ
Pin 9
Pin 9
Table 8: Cable pins - I2C MUX to Supermicro backplane
2
Signal
Supermicro 836TQ
I
C MUX
SDA
Pin 1
Pin 1
Ground
Pin 2
Pin 2
SCL
Pin 3
Pin 3
Not Connected
Pin 4
Pin 4
For additional information about using the enclosure services of your
Supermicro Backplane, please consult the documentation that came
with your chassis or backplane.
7