AUDIOLINE SENSOR 500 Panduan Pengguna - Halaman 18
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Telepon AUDIOLINE SENSOR 500. AUDIOLINE SENSOR 500 19 halaman. Audioline sensor 500 initial setup
Juga untuk AUDIOLINE SENSOR 500: Manual (1 halaman), Panduan Pengaturan Awal (1 halaman)
Halaman CetakTROUBLE SHOOTING
THE RED LED INDICATOR ON THE BASE UNIT IS FLASHING
· There is a message waiting in your Network voice message system.
INCOMING NUMBERS ARE NOT VISIBLE ON THE DISPLAY
· Have you subscribed to the caller display service?
· If "Out of area" or "Withheld Secret" are displayed, it either means that no
information of the number is available or that the caller has withheld their
number.
· Is the phone connected to a PABX? Caller display is not available when
connected to a PABX.
THE TELEPHONE DOES NOT WORK
· Check that the ringer is switched on.
· Does the total of RN numbers exceed 4? If it does, disconnect other
equipment until 4 is achieved.
NO DIALLING TONE
· Is the telephone line cord plugged into a telephone network wall socket?
MEMORY DIALLING DOES NOT WORK
· Store a number and try again.
RN
The RN (Ringer Equivalance Number) is of significance only if you wish to
connect more than 1 telephone to your telephone line. Your telephone line has a
maximum RN capacity of 5. Your Audioline Sensor500 has a RN of 0.5, thus it is
feasible to connect 4 more telephones of a value of 1 to your system. You
should not exceed a value of 5 on the complete system, otherwise the volume of
the ringer in any phone will decrease and one telephone may not ring at all.
17