- ページ 18

電話 AUDIOLINE SENSOR 500のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AUDIOLINE SENSOR 500 19 ページ。 Audioline sensor 500 initial setup
AUDIOLINE SENSOR 500 にも：マニュアル (1 ページ), 初期設定マニュアル (1 ページ)

ページを印刷する

TROUBLE SHOOTING

THE RED LED INDICATOR ON THE BASE UNIT IS FLASHING

· There is a message waiting in your Network voice message system.

INCOMING NUMBERS ARE NOT VISIBLE ON THE DISPLAY

· Have you subscribed to the caller display service?

· If "Out of area" or "Withheld Secret" are displayed, it either means that no

information of the number is available or that the caller has withheld their

number.

· Is the phone connected to a PABX? Caller display is not available when

connected to a PABX.

THE TELEPHONE DOES NOT WORK

· Check that the ringer is switched on.

· Does the total of RN numbers exceed 4? If it does, disconnect other

equipment until 4 is achieved.

NO DIALLING TONE

· Is the telephone line cord plugged into a telephone network wall socket?

MEMORY DIALLING DOES NOT WORK

· Store a number and try again.

The RN (Ringer Equivalance Number) is of significance only if you wish to

connect more than 1 telephone to your telephone line. Your telephone line has a

maximum RN capacity of 5. Your Audioline Sensor500 has a RN of 0.5, thus it is

feasible to connect 4 more telephones of a value of 1 to your system. You

should not exceed a value of 5 on the complete system, otherwise the volume of

the ringer in any phone will decrease and one telephone may not ring at all.