AUDIOLINE Baby Care 33 Panduan Petunjuk Pengoperasian - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Monitor Bayi AUDIOLINE Baby Care 33. AUDIOLINE Baby Care 33 16 halaman.

Operation

4 Operation

Once you have set up your baby monitor, you will be able to hear the sounds in your baby´s

room through the parent unit. You will also be able to see those sounds as the sound sensor

lights around the top of the parent unit, which rise and fall with the volume level.

Note: If the connection between parents and baby unit is worse, because you leave the

range, for example, the transmission may be chopped and the device emits two short beeps.

The connection may break down completely. To re−establish the "Link", follow the directions

in the "Troubleshooting" chapter.

Powering on/off the baby monitor

After having connected the baby monitor you will have to switch on the parent's unit. Press

and hold down the

the

On/Off key

Volume

You can adjust the volume at which you hear your baby by using the keys

parent unit. This will not effect the sensitivity of your baby monitor, only the volume at which

you hear those sounds through the parent unit.

Battery charge indicator and battery low warning

The parent unit will work up to 5 hours without charging, but this depends on the level of

charge in the batteries. If the charge becomes low, the power LED on the parent unit´s will

begin to flash. If this occurs you should connect the parent unit to the charger to re−charge

the batteries. You can still use your parent unit during charging.

for approx. 2 sec. To switch off the unit press and hold down

On/Off key

for approx. 2 sec. again.

Service-Hotline Germany: Tel. 0180 5 001388 (Costs for call from german

landline at time of print: 14 ct/min, max. 42 ct/min from mobile phone providers.)

▲

▼

and

on the