AUDIOLINE Baby Care 33 Operating Instructions Manual - Page 12
Browse online or download pdf Operating Instructions Manual for Baby Monitor AUDIOLINE Baby Care 33. AUDIOLINE Baby Care 33 16 pages.
Print Page
Operation
4 Operation
Once you have set up your baby monitor, you will be able to hear the sounds in your baby´s
room through the parent unit. You will also be able to see those sounds as the sound sensor
lights around the top of the parent unit, which rise and fall with the volume level.
a
Note: If the connection between parents and baby unit is worse, because you leave the
range, for example, the transmission may be chopped and the device emits two short beeps.
The connection may break down completely. To re−establish the "Link", follow the directions
in the "Troubleshooting" chapter.
Powering on/off the baby monitor
After having connected the baby monitor you will have to switch on the parent's unit. Press
and hold down the
the
On/Off key
Volume
You can adjust the volume at which you hear your baby by using the keys
parent unit. This will not effect the sensitivity of your baby monitor, only the volume at which
you hear those sounds through the parent unit.
Battery charge indicator and battery low warning
The parent unit will work up to 5 hours without charging, but this depends on the level of
charge in the batteries. If the charge becomes low, the power LED on the parent unit´s will
begin to flash. If this occurs you should connect the parent unit to the charger to re−charge
the batteries. You can still use your parent unit during charging.
10
for approx. 2 sec. To switch off the unit press and hold down
On/Off key
for approx. 2 sec. again.
Service-Hotline Germany: Tel. 0180 5 001388 (Costs for call from german
landline at time of print: 14 ct/min, max. 42 ct/min from mobile phone providers.)
▲
▼
and
on the