aevit 2.0 Panduan Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Dudukan TV aevit 2.0. aevit 2.0 17 halaman. Mounting brackets

Halaman Cetak

prIMArY INpUT

2.3 MOUNTINg BASE INSTALLATION - dOOr

Before installing the Door Mounting system, verify that the following components are included with the BRKT-AEVIT-

DOOR mounting kit:

(1) Door Base Plate

(1) Input Device Articulating Arm Bracket (6) 1/4" x 1" hex head Bolts

(1) Upper Pole Mounting Plate

(1) Input Device Mounting Ball

(1) Mounting Ball hardware Kit

(5) Bolt Caps

Once all components are verified as present, the Door Base Plate can be attached directly to the door as shown in Fig-

ure 5 below. This universal plate will be mounted to the OEM driver's door with no less than (5) bolts and locknuts for

the vehicles shown. The four bosses protruding out from the door plate will go through the door panel to accept the

quick Adjust Upper Pole. Figure 6 shows the Door Base Plate and references possible mounting holes for individual

vehicle manufacturers.

dOOr BASE

pLATE

dOOr BASE

pLATE BOSSES

BASE pLATE

SpACErS

FIGuRE 5

This rendering shows how the door mounting sys-

tem will eventually go together. The Door Base Plate

is hidden behind the panel with the (4) protrusions

and/or spacers coming through the OEM door panel.

(4) 5/16" x 3" hex head Bolts

(4) 5/16" Lock Washers

(6) 1/4" KEP Nuts

(4) Base Plate Spacers

(1) Additional Spacer*

UppEr pOLE

MOUNTINg pLATE

5/16"x3"

BOLTS

(holes marked with F s & T s will require the additional spacer* behind the plate.)

PANEL MOUNTING CLIPS FOR ALL VEhICLES. ThESE VOID AREAS

(BrkT-AEVIT-dOOr)

IF ANy OF ThESE COMPONENTS ARE NOT

INCLUDED WITh ThE BRKT-AEVIT-DOOR, CALL

ThE EMC SERVICE DEPARTMENT. dO NOT AT-

TEMpT TO INSTALL wIThOUT ALL pArTS.

C - Chrysler F - Ford T - Toyota h - honda

F T

C F h

Door Panel Mounting

Clip Area

C F T h

NOTE:

ThE DOOR BASE PLATE IS DESIGNED TO AVOID OEM DOOR

MUST BE CONSIDERED WhEN PLACING ThE PLATE FOR hOLE

DRILLING.

WARNING:

ALL MOUNTING hARDWARE AND FASTENERS MUST BE PROP-

ERLy TIGhTENED TO PREVENT UNINTENDED MOVEMENT OF

ThE INPUT DEVICE(S) AND MOUNTING BRACKETS. FAILURE TO

OBSERVE ThIS WARNING MAy RESULT IN AN ACCIDENT CAUS-

ING SERIOUS INjURy AND/OR DEATh.

AEVIT 2.0 MOUNTING BRACKETS INSTALL MANUAL

NOTE:

C F s h

C F h

FIGuRE 6

2-3

C F h T s