aevit 2.0 Kurulum Kılavuzu - Sayfa 6

TV Montajı aevit 2.0 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. aevit 2.0 17 sayfaları. Mounting brackets

Sayfayı Yazdır
prIMArY INpUT

2.3 MOUNTINg BASE INSTALLATION - dOOr

Before installing the Door Mounting system, verify that the following components are included with the BRKT-AEVIT-
DOOR mounting kit:
(1) Door Base Plate
(1) Input Device Articulating Arm Bracket (6) 1/4" x 1" hex head Bolts
(1) Upper Pole Mounting Plate
(1) Input Device Mounting Ball
(1) Mounting Ball hardware Kit
(5) Bolt Caps
Once all components are verified as present, the Door Base Plate can be attached directly to the door as shown in Fig-
ure 5 below. This universal plate will be mounted to the OEM driver's door with no less than (5) bolts and locknuts for
the vehicles shown. The four bosses protruding out from the door plate will go through the door panel to accept the
quick Adjust Upper Pole. Figure 6 shows the Door Base Plate and references possible mounting holes for individual
vehicle manufacturers.
dOOr BASE
pLATE
dOOr BASE
pLATE BOSSES
BASE pLATE
SpACErS
FIGuRE 5
This rendering shows how the door mounting sys-
tem will eventually go together. The Door Base Plate
is hidden behind the panel with the (4) protrusions
and/or spacers coming through the OEM door panel.
(4) 5/16" x 3" hex head Bolts
(4) 5/16" Lock Washers
(6) 1/4" KEP Nuts
(4) Base Plate Spacers
(1) Additional Spacer*
UppEr pOLE
MOUNTINg pLATE
5/16"x3"
BOLTS
(holes marked with F s & T s will require the additional spacer* behind the plate.)
PANEL MOUNTING CLIPS FOR ALL VEhICLES. ThESE VOID AREAS
(BrkT-AEVIT-dOOr)
IF ANy OF ThESE COMPONENTS ARE NOT
INCLUDED WITh ThE BRKT-AEVIT-DOOR, CALL
ThE EMC SERVICE DEPARTMENT. dO NOT AT-
TEMpT TO INSTALL wIThOUT ALL pArTS.
C - Chrysler F - Ford T - Toyota h - honda
F T
T
C F h
Door Panel Mounting
Clip Area
C F T h
NOTE:
ThE DOOR BASE PLATE IS DESIGNED TO AVOID OEM DOOR
MUST BE CONSIDERED WhEN PLACING ThE PLATE FOR hOLE
DRILLING.
WARNING:
ALL MOUNTING hARDWARE AND FASTENERS MUST BE PROP-
ERLy TIGhTENED TO PREVENT UNINTENDED MOVEMENT OF
ThE INPUT DEVICE(S) AND MOUNTING BRACKETS. FAILURE TO
OBSERVE ThIS WARNING MAy RESULT IN AN ACCIDENT CAUS-
ING SERIOUS INjURy AND/OR DEATh.
AEVIT 2.0 MOUNTING BRACKETS INSTALL MANUAL
NOTE:
C F s h
C F h
FIGuRE 6
2-3
T
C F h T s